Hook & Eye C10341 Hinge pins are not removable

Hinge pins are not removable (tight pin)

Each shutter fastener requires three #8 screws

Hinge pin is removable

must be in exact alignment to each other (tolerance not to exceed plus or minus 1/16")

you can install two hinges end to end with no loss of strength

Hook & Eye C10341 Hinge pins are not removableUsed to secure shutters, gates, screens and doors. Available in 3 lengths Mounting plates measure approximately 1 1 2" (Please note that the 6" and 12" size have square mounting plates, the 8" will come with round mounting plates). Size is measured from the center of the loop to the end of the hook. Hook and Eye comes with a mounting plate at one end and an "Eye" plate at the hook end.